Set Syslog-Notification - Fujitsu Eternus DX100 S3 User Manual

Chapter 5 System Settings and Display
5.3 System Settings > set syslog-notification

set syslog-notification

This command sets up an association with the syslog server.
■
Syntax
set syslog-notification
[-server1-function {disable | rfc3164 | rfc5424}]
[-server1 syslog-server1
[-server1-port {maintenance | remote}]
[-server2-function {disable | rfc3164 | rfc5424}]
syslog-server2
[-server2
[-server2-port-number
[-server2-port {maintenance | remote}]
■ Parameter
-server1-function
-server1
-server1-port-number
] [-server1-port-number
]
port_number
]
Optional. This parameter specifies whether to enable syslog server 1. If this parameter is
omitted, this setting is not changed.
disable Syslog server 1 is disabled.
rfc3164 Syslog server 1 is enabled and uses message format based on RFC3164.
rfc5424 Syslog server 1 is enabled and uses message format based on RFC5424.
Optional. This parameter specifies syslog server 1. Only one server can be specified. The server
name format should be IPv4 standard notation (a base 256 "d.d.d.d" string), IPv6 address
format, or a fully qualified domain name (FQDN). The types of IPv6 addresses that can be
specified are global addresses (including 6to4 addresses), link local addresses, and unique
local addresses. Up to 63 alphanumeric characters can be specified. If this parameter is
omitted, this setting is not changed.
Example: -server1 192.168.1.20
Example: -server1 fd80::abd0:223:ad
Example: -server1 foo.bar
syslog-server1
Server name of syslog server 1
Optional. This parameter specifies syslog server 1's UDP port number for the syslog protocol.
Specify the port number within 1 to 5 digits. The port number cannot be set above 65535. If
omitted, the setting is not changed. The default value is 514.
port_number
Syslog server 1's UDP port number
ETERNUS CLI User's Guide
Copyright 2014 FUJITSU LIMITED
port_number ]
628
P2X0-1210-05ENZ0