Fujitsu Eternus DX100 S3 User Manual page 744

Chapter 7 NAS Function Setting and Display
7.1 Shared Folders > set nas-share
-cifs-allow-host
The following formats are available:
• single host
Example: 10.123.123.123
• netgroup
Example: @group
• IP network
Example: 10.123.123.0/255.255.255.0
However, the specified string is not checked. Therefore, use of a format other than the above
does not result in an error.
There is no limit on the number of characters (limited by the maximum length, 5,120
characters, of a CLI command.) To delete a setting, specify a null character ("").
allow-host Host that is allowed to access the shared folder
"" The setting is deleted.
Optional. This parameter specifies the host that is allowed to access the shared folder. Multiple
hosts can be specified by inserting a comma (,) between them as a delimiter. If omitted, this
parameter is not changed. This parameter can be specified only when CIFS or NFS/CIFS is used
as the protocol.
Specify the hosts, including ones that have already been allowed.
The following formats are available:
• single host
Example: 10.123.123.123
• netgroup
Example: @group
• IP network
Example: 10.123.123.0/255.255.255.0
• EXCEPT
Only the specific hosts can be excepted from access using "EXCEPT" (based on the format of
Samba).
Example: 150.203.* EXCEPT 150.203.6.66
However, the specified string is not checked. Therefore, use of a format other than the above
does not result in an error.
There is no limit on the number of characters (limited by the maximum length, 5,120
characters, of a CLI command.) To delete a setting, specify a null character ("").
allow-host
Host that is allowed to access the shared folder
"" The setting is deleted.
ETERNUS CLI User's Guide
Copyright 2014 FUJITSU LIMITED
744
P2X0-1210-05ENZ0