Fujitsu Eternus DX100 S3 User Manual page 847

Appendix A Error Messages/Error Codes
A.1 Error Messages
Message
number
E5386
E5387
E5388
E5389
E5390
E5391
E5392
E5393
E5394
E5395
E5396
E5400
E5401
E5402
E5501
E5502
E5503
The copy path is not in "Normal" state. Copy sessions in this storage were deleted but copy sessions in the
remote old model storage still exist.
A session could be deleted in the local ETERNUS DX but could not be deleted in the remote ETERNUS DX
that is an older model because of an error in the path status.
In the remote old model storage, firmware update is in progress. The specified operation cannot be done.
The command cannot be processed in the connection destination ETERNUS storage system that is an
older model because CFL is being performed.
Copy resolution settings of the local storage and remote old model storage are different.
The storage system resolution is not the same between the copy source (older model) and the copy
destination.
In the remote old model storage, an error, which can be recovered by retry, occurred.
An recoverable error occurs for a retry operation in the connection destination ETERNUS storage system
that is an older model.
The remote old model storage is in "Not Ready" or internal error state.
The connection destination ETERNUS storage system that is an older model is in NotReady status or an
error event occurred in the firmware of the connection destination ETERNUS storage system that is an
older model.
There is not the certification of consistency.
The Concurrent OPC error recovered (this does not guarantee data integrity).
Multiple copy source storage exists.
The copy destination to which the command was issued has multiple copy source ETERNUS storage
systems.
The certification of consistency is unknown.
The Concurrent OPC warning recovered (this may or may not guarantee data integrity).
The copy source storage is not support this command.
The command that is issued to the copy destination is not supported by the copy source.
Controller Module failed.
Copy session control failed because a CM degraded.
The remote storage is not supported this function.
The firmware of the remote ETERNUS storage systems does not support REC.
The same command that was issued by specifying by start has already been processed.
The same command that is specified by start is already being processed.
The same command that was issued by specifying by restart has already been processed.
The same command that is specified by restart is already being processed.
REC transfer mode which specified by Start or Resume command is invalid at all RA ports which configure
path.
The REC transfer mode that is specified by the Start command or the Resume command is invalid for all of
the RA ports that configure the path.
iSNS server cannot be connected from the specified iSCSI CA port.
The iSNS server is not set for the specified iSCSI CA port.
CLI cannot change the host or port parameter setting created by GUI.
A host name and port setting that are created with GUI cannot be changed by CLI.
The Multiple VLAN setting of a specified port is invalid.
The multiple VLAN setting of the specified port is invalid.
ETERNUS CLI User's Guide
Copyright 2014 FUJITSU LIMITED
Message
Countermeasure for the error
847
P2X0-1210-05ENZ0