Fujitsu Eternus DX100 S3 User Manual page 832

Appendix A Error Messages/Error Codes
A.1 Error Messages
Message
number
E0143
E0145
E0146
E0150
E0151
E0152
E0153
E0154
E0155
E0156
E0157
E0158
E0159
E0160
Unexpected error occurred during operator intervention.
During operator intervention, an unexpected error occurred (Example: the terminal session was suddenly
disconnected). Try the operation again.
Advanced Copy table exists.
Advanced Copy table has already been defined in the system. Check the Advanced Copy table size by
using the "show advanced-copy-parameters" command. The table size should be zero.
Set the Advanced Copy table size to 0 by using the "set advanced-copy-parameters" command if neces-
sary.
RAID group contains a temporary volume.
Could not execute because a temporary volume exists in the RAID group. If necessary, retry the command
after deleting the temporary volume.
Collecting performance data.
Performance data is currently being collected. Wait for a while and retry the command.
Power-off or power-on in process.
Could not execute while the system is turning on or turning off. Try again after the system has completed
powering-on.
Volumes formatting in process.
Could not execute while volumes are formatting. Check the progress status of the volumes using the
"show volume-progress" command.
Try again after formatting is complete.
Encryption or decryption of volumes in process.
Could not execute while volumes are being encrypted or decrypted. Please check the progress of volumes
operations by using the "show volume-progress" command.
Try again after volume encryption or decryption is complete.
Advanced Copy session active.
Could not execute while Advanced Copy sessions are processing. Check the status by using the "show
advanced-copy-sessions" command and wait for the session to complete before retrying the command.
Try again after the Advanced Copy sessions starts up.
Volumes migration in process.
Could not execute while volumes are being migrated. Check the progress status of volumes by using the
"show migration" command.
RAID group expansion in process.
Could not execute while a RAID group is being expanded. Check the progress status of RAID group
operations by using the "show raid-group-progress" command.
Remote Copy session active.
Could not execute while Remote Copy sessions are processing. Check the status using GUI or ACM
(ETERNUS SF AdvancedCopy Manager).
Controller firmware update in process.
Could not execute while controller firmware update is processing. Wait for a while and retry the command
after the controller firmware update is complete.
Remote maintenance in process.
Could not execute while remote maintenance is processing. Wait for a while and retry the command after
remote maintenance is complete.
Competing with background process.
Some operations are being performed by another process. Wait for a while and try again.
ETERNUS CLI User's Guide
Copyright 2014 FUJITSU LIMITED
Message
Countermeasure for the error
832
P2X0-1210-05ENZ0