Show Host-Path-State - Fujitsu Eternus DX100 S3 User Manual

Chapter 3 Configuration Settings and Display
3.5 Host Interface Management > show host-path-state

show host-path-state

This command displays the path status (access availability status from the target host) that is defined in the
mapping of the associated host interface ports that are set.
■ Syntax
show host-path-state [-port {
■ Parameter
-port
■ Output
Port
Host
Path State
■ Example(s)
The following example displays the status of all of the paths for all of the associated host interface ports:
CLI> show host-path-state
Port
---------------- ---- ---------------- ----------
CM#0 CA#0 Port#0
CM#0 CA#0 Port#0
CM#1 CA#0 Port#1
CM#1 CA#0 Port#1
xyz
|all}]
Optional. This parameter specifies the host interface port that is to be displayed. Multiple
parameters can be set by separating each one by a comma (,). If omitted, the process is
performed as if all of the host interface ports are selected.
Example: -port 000,100
For details, refer to "1.2.15 Host Interface Port Syntax" (page
xyz "x" is the controller module (CM) number, "y" is the CA number, and "z" is the
host port number.
Example: 123 (host port#3 of CA#2 on CM#1)
all All of the host interface ports (default)
Port number
Host identifiers
No. Host number
Name Host name
Access availability status from the target host
Host
No. Name
0 FC#0
1 FC#1
0 FC#0
1 FC#1
ETERNUS CLI User's Guide
Copyright 2014 FUJITSU LIMITED
Path State
Online
Online
Online
Offline
333
29).
P2X0-1210-05ENZ0