Show Fc-Parameters - Fujitsu Eternus DX100 S3 User Manual

Chapter 3 Configuration Settings and Display
3.5 Host Interface Management > show fc-parameters

show fc-parameters

This command displays the parameters of each FC host interface port.
■
Syntax
show fc-parameters
■ Parameter
No parameters.
■ Output
Port
Port Mode
Connection Connection of each FC port (loop connection (FC-AL) or fabric connection)
Loop ID Assign
Transfer Rate
Frame Size
Host Affinity
Host Response No.
Host Response Name
Reset Scope Range of reset action I_T_L (I: Initiator, T: Target, L: LUN) or T_L (T: Target, L: LUN)
Reserve Cancel at Chip Reset
REC Line No.
REC Transfer Mode Sync
Each host interface port number
Indicates whether either CA or RA mode is set. The RA mode is used for Remote Equivalent
Copy.
How to assign the loop ID (Loop ID is shown only when selecting manual.) (Either ascending
order or descending order is shown when selecting automatic.)
FC transfer rate (Auto Negotiation / 4Gbit/s / 8Gbit/s / 16Gbit/s)
FC frame size (512bytes/1024bytes/2048bytes)
Host affinity mode of each host interface port
Host response number (A hyphen (-) is displayed when the host affinity mode is enabled.)
Host response name (A hyphen (-) is displayed when the host affinity mode is enabled.)
Indicates whether reservations are canceled or not when a host interface port is reset.
REC line number (0 – 127)
(A hyphen (-) is displayed in the field when the port mode is not the RA mode or the CA/RA
auto mode.)
Synchronous mode for the REC transfer mode (Enable: enabled, Disable: disabled)
(A hyphen (-) is displayed in the field when the port mode is not the RA mode or the CA/RA
auto mode.)
ETERNUS CLI User's Guide
Copyright 2014 FUJITSU LIMITED
222
P2X0-1210-05ENZ0