Set Host-Sas-Address - Fujitsu Eternus DX100 S3 User Manual

Chapter 3 Configuration Settings and Display
3.5 Host Interface Management > set host-sas-address

set host-sas-address

This command changes the details of an existing SAS host.
■
Syntax
set host-sas-address {-host-number
address
[-address
-host-response-name
■ Parameter
-host-number
or
-host-name
-address
-name
-host-response-number
or
-host-response-name
host_number
name
] [-name ] [-host-response-number
host_response_name
This parameter specifies the identifier of the SAS host whose details are to be changed. If only
the host response identifier is being set, then one or more SAS host identifiers can be specified
at the same time. If not, then only one SAS host identifier can be specified. For details, refer to
"1.2.11 Host Syntax" (page
host_number
SAS host number
host_name
SAS host name
Optional. This parameter specifies the SAS address, which is a 16 character hexadecimal
number that corresponds to a HBA. Only one SAS address can be specified at any given time. If
omitted, the existing setting is not changed.
Example: -address 500605b000b5f344
address SAS address
Optional. This parameter specifies the new SAS address alias. Only one name can be specified
at the same time. For details, refer to
existing setting is not changed.
name
SAS address alias
Optional. This parameter specifies a host response identifier. One or more parameters can be
specified at the same time. For details, refer to
omitted, the existing setting is not changed.
host_response_number
Host response number
host_response_name
Host response name
ETERNUS CLI User's Guide
Copyright 2014 FUJITSU LIMITED
host_name
| -host-name
host_response_number
]
27).
"1.2.5 Alias Name Syntax" (page
"1.2.13 Host Response Syntax" (page
267
}
|
23). If omitted, the
28). If
P2X0-1210-05ENZ0