Show Nas-Route - Fujitsu Eternus DX100 S3 User Manual

Chapter 7 NAS Function Setting and Display
7.5 Network Settings > show nas-route

show nas-route

This command displays IPv4 route information of the NAS interface.
■
Syntax
show nas-route [-mode { startup | current}]
■ Parameter
-mode
■ Output
When the "startup" option is specified:
Target
Destination IP address of the target network or host
Gateway
Genmask
NAS Interface No.
When the "current" option is specified:
Destination IP address of the target network or host
Gateway
Genmask
Flags
Iface
Optional. This parameter specifies route information to be displayed.
startup Information is displayed regarding the static route that is to be specified when
the system starts (default).
current The current IP routing table is displayed for each CM.
Indicates whether the target is a network or host.
Gateway address
Netmask of the target network
NAS interface number
Gateway address
Netmask of the target network
Routing flag
NAS interface number
ETERNUS CLI User's Guide
Copyright 2014 FUJITSU LIMITED
778
P2X0-1210-05ENZ0