Fujitsu Eternus DX100 S3 User Manual page 246

Chapter 3 Configuration Settings and Display
3.5 Host Interface Management > set iscsi-parameters
-cmdsn-count
-vlan-id
-vlan-id-value
-mtu
-bandwidth Optional. This parameter specifies the bandwidth limit when iSCSI-RA (only for connecting
Optional. For Advanced authority users, this parameter specifies the number of commands
that are simultaneously acceptable from a host. The initial value is set to unlimited. This
parameter cannot be specified when the port is set to the RA mode.
unlimited The number of commands is not limited.
20 Limited to a maximum of 20 commands.
40 Limited to a maximum of 40 commands.
80 Limited to a maximum of 80 commands.
120 Limited to a maximum of 120 commands.
180 Limited to a maximum of 180 commands.
Optional. This parameter specifies VLAN connection enable or disabled. When "enable" sets,
must be set the "-vlan-id-value" parameter. To set "enable", the "-vlan-id-value" parameter
must be set.
This parameter can be specified as a parameter for the multiple IP address setting.
enable VLAN connection enabled.
disable VLAN connection disabled.
Optional. This parameter specifies the VLAN ID value for connect to VLAN. When "-vlan-id
enable" is done, this parameter must be set. "-vlan-id" must be set to "enable" for this
parameter. This parameter can be specified as a parameter for the multiple IP address setting.
0 – 4095 VLAN ID value (0 – 4095)
Optional. Specify the MTU size when RA is used. The specified value is only valid when the RA
mode or CA/RA auto mode is used. The initial value is 1300. From 576 to 9000 can be specified
when IPv6 is disabled and from 1280 to 9000 can be specified when IPv6 is enabled. If
omitted, the existing setting is not changed.
mtu_size
MTU size (576 – 9000)
older models) is used. The specified value is only valid for iSCSI-RA, which is only used for
connecting older models. The initial value is 400Mbit/s. The allowed range is from 10 to 400. If
omitted, the existing setting is not changed.
bandwidth_limit
Bandwidth limit (upper limit performance value) (10 – 400)
ETERNUS CLI User's Guide
Copyright 2014 FUJITSU LIMITED
246
P2X0-1210-05ENZ0