Fujitsu Eternus DX100 S3 User Manual page 648

Chapter 5 System Settings and Display
5.3 System Settings > set sed-key-group
-period
-master-server-id
-slave-server-id
■ Example(s)
The following example modifies the key group:
CLI> set sed-key-group -name key-group2 -machine-group-name machine_group2 -security-level low -recovery
-mode manual -period "" -master-server-id 2 -slave-server-id 1
Optional. This parameter specifies the valid period of the key. This period can be specified on a
monthly basis by using a number from 1 to 12. Specify a null character ("") or omit this param-
eter to not set this period. If omitted, the existing setting is not changed.
period
Valid period of the key (1 – 12)
"" The valid period of the key is not set.
Optional. This parameter specifies the key server ID for the master server. 1 or 2 can be speci-
fied. When the master server is not used, specify a null character (""). If omitted, the existing
setting is not changed. Use the same setting as the master server that is set in the key server.
master_server_id
Key server ID for the master server (1 or 2)
"" The key server ID is omitted.
Optional. This parameter specifies the key server ID for the slave server. 1 or 2 can be specified.
When the slave server is not used, specify a null character (""). If omitted, the existing setting
is not changed. Use the same setting as the slave server that is set in the key server.
master_server_id
Key server ID for the slave server (1 or 2)
"" The key server ID is omitted.
ETERNUS CLI User's Guide
Copyright 2014 FUJITSU LIMITED
648
P2X0-1210-05ENZ0