Chapter 7 NAS Function Setting and Display
7.3 Network Interface Bonding > set nas-bonding
set nas-bonding
This command configures NAS port bonding settings. Up to 15 member ports can be assigned to a single
master port.
This command is unavailable when firmware version V10L20 is being used.
■
Syntax
set nas-bonding -master-port
[-mode {0|1|2|4|5|6}] [-hash-policy {L2|L23|L34}]
■
Parameter
-master-port
-member-port
port1
-member-port
This parameter specifies the port that is to be set as the master port.
•
The following ports cannot be specified:
-
Ports other than the NAS port
-
Ports that are already specified as a member port
-
Ports with multipath settings
•
The settings of the NAS interface port that is assigned to the member port are retained.
port1
Master port
Example: -master-port 001
This parameter specifies the ports that are to be set as member ports. Multiple member ports
can be specified by inserting a comma (,) between them as a delimiter.
To add a member port, specify only the target port. If a port that has already been assigned to
a member port of the target master port is specified, it does not cause an error.
•
The following ports cannot be specified:
-
Ports other than the NAS port
-
Ports that are specified as a master port
-
Ports that are specified as a member port for other master ports
-
Ports with multipath settings
-
Ports with different CMs from the master port
•
The settings of the NAS interface port that is assigned to the member port are deleted.
ETERNUS CLI User's Guide
Copyright 2014 FUJITSU LIMITED
port2
port3
,
,...
762
P2X0-1210-05ENZ0