Start Advanced-Copy - Fujitsu Eternus DX100 S3 User Manual

Chapter 4 Copy Function Settings and Display
4.1 Advanced Copy Management > start advanced-copy

start advanced-copy

This command starts an Advanced Copy SnapOPC+ session. All other Copy types cannot be started using this
command.
■ Syntax
start advanced-copy
{-source-volume-number
{-destination-volume-number
■
Parameter
-source-volume-number
or
-source-volume-name
-destination-volume-number
or
-destination-volume-name
■ Example(s)
The following example starts an Advanced Copy session from the volume named "OPEN1" to the volume
named "SDV1":
CLI> start advanced-copy -source-volume-name OPEN1 -destination-volume-name SDV1
volume_number
sdv_number
This parameter specifies the volume identifier of the copy source. The volume type must be
OPEN. Only one volume can be specified at the same time. For details, refer to
Syntax" (page 26).
volume_number
Copy source volume number
volume_name
Copy source volume name
This parameter specifies the volume identifier of copy destination. The type must be SDV. Only
one volume can be specified at the same time. For details, refer to
(page 26).
sdv_number
Copy destination volume number
sdv_name Copy destination volume name
ETERNUS CLI User's Guide
Copyright 2014 FUJITSU LIMITED
| -source-volume-name volume_name
| -destination-volume-name
420
}
sdv_name
}
"1.2.10 Volume
"1.2.10 Volume Syntax"
P2X0-1210-05ENZ0