Chapter 5 System Settings and Display
5.2 Network Management > show snmp
show snmp
This command displays the SNMP parameters.
■
Syntax
show snmp
■
Parameter
No parameters.
■
Output
SNMP
Port
Authentication Failure
Engine ID
MIB-II RFC Version
■
Example(s)
The following example displays the SNMP parameters:
CLI> show snmp
SNMP [Enable]
Port [MNT]
Authentication Failure [Enable]
Engine ID [0x000102030405060708090a0b0c0d0e0f101112131415161718191a1b1c1d1e1f]
MIB-II RFC Version [RFC1213]
The following example displays the SNMP parameter that uses the RMT port and the default engine
identifier.
CLI> show snmp
SNMP [Enable]
Port [RMT]
Authentication Failure [Enable]
Engine ID [0x800000d380500000e0d0401400] (Default)
MIB-II RFC Version [RFC4293]
Indicates whether SNMP functions are enabled.
LAN port to use SNMP functions
Indicates whether to notify Authentication Failure by an SNMP trap when the system is
accessed from undefined SNMP communities.
Engine identifier. This information is followed by "(Default)" when the "-engine-id default"
parameter is specified for the "set snmp" command.
Indicates the version of MIB-II that is used by the ETERNUS DX.
ETERNUS CLI User's Guide
Copyright 2014 FUJITSU LIMITED
509
P2X0-1210-05ENZ0