Set Role - Fujitsu Eternus DX100 S3 User Manual

Chapter 5 System Settings and Display
5.1 User Management > set role

set role

This command changes the registered user-defined role information. Note that this command cannot change
the role name or the role types. This command can also change the role that is currently assigned to the user.
Any changes are enabled after the next login.
■ Syntax
set role -role-name
■ Parameter
-role-name This parameter specifies a role name. Two or more parameters cannot be specified at the same
-policy
role_name [-policy policy
time.
role_name
Role name
Optional. This parameter specifies policies to set for the role. Use the numbers that are listed
below to specify policies. Multiple policies can be specified by separating them with a comma
(,) or a hyphen (-). Note that spaces are not permitted before or after commas (,).
If omitted, this parameter is not changed.
policy Policy that is assigned to the role
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
ETERNUS CLI User's Guide
Copyright 2014 FUJITSU LIMITED
]
Status Display
RAID Group Management
Volume - Create/Modify
Volume - Delete/Format
Host Interface Management
Advanced Copy Management
Copy Session Management
Storage Migration Management
Resource Domain Management (not supported)
Storage Management
User Management
Authentication/Role
Security Setting
Audit Setting (not supported)
Maintenance Information
Maintenance Operation
Software Control (not supported)
Firmware Management
NAS Management
471
P2X0-1210-05ENZ0