Chapter 5 System Settings and Display
5.3 System Settings > set storage-system-name
set storage-system-name
This command sets the ETERNUS DX information. Note that the Virtual Disk Service (VDS) "Friendly" name
corresponds to the ETERNUS DX name.
■
Syntax
set storage-system-name [-name
[-contact
contact
■
Parameter
-name
-installation-site
-contact
-description Optional. This parameter specifies the description of the ETERNUS DX (up to 50 characters).
■
Example(s)
The following example sets the ETERNUS DX name, installation site name, descriptions, and contact address:
CLI> set storage-system-name -name E2000-No1 -installation-site FJ -contact AVRIL -description CALC2
name
] [-installation-site
] [-description
description
Optional. This parameter specifies the ETERNUS DX name (up to 16 characters). Permitted
characters are described in
existing setting is not changed.
name
ETERNUS DX name
Optional. This parameter specifies the installation site name (up to 50 letters). Permitted
characters are described in
existing setting is not changed.
location
Installation site name
Optional. This parameter specifies the administrator address (up to 50 characters). Permitted
characters are described in
existing setting is not changed.
contact
Administrator address
Permitted characters are described in
the existing setting is not changed.
description
Description of the ETERNUS DX
ETERNUS CLI User's Guide
Copyright 2014 FUJITSU LIMITED
location
]
"1.2.2 Keywords and Parameters" (page
"1.2.2 Keywords and Parameters" (page
"1.2.2 Keywords and Parameters" (page
"1.2.2 Keywords and Parameters" (page
610
]
22). If omitted, the
22). If omitted, the
22). If omitted, the
22). If omitted,
P2X0-1210-05ENZ0