Start Performance - Fujitsu Eternus DX100 S3 User Manual

Chapter 6 Information Settings and Display
6.1 Performance > start performance

start performance

This command starts the collection of performance information. If performance information is already being
collected, then the command terminates with an error message.
■ Syntax
start performance [ -interval { 30 | 60 | 90 | 120 | 150 | 180 | 210 | 240 | 270 | 300 } ]
■ Parameter
-interval
■ Example(s)
The following example starts collecting the performance information at 30 seconds intervals:
CLI> start performance -interval 30
Optional. This parameter specifies the update interval for performance information. A unit is
second. If omitted, the default value (30 seconds) is used.
30 Updated every 30 seconds (default).
60 Updated every 60 seconds.
90 Updated every 90 seconds.
120 Updated every 120 seconds.
150 Updated every 150 seconds.
180 Updated every 180 seconds.
210 Updated every 210 seconds.
240 Updated every 240 seconds.
270 Updated every 270 seconds.
300 Updated every 300 seconds.
ETERNUS CLI User's Guide
Copyright 2014 FUJITSU LIMITED
662
P2X0-1210-05ENZ0