Fujitsu Eternus DX100 S3 User Manual page 874

Appendix A Error Messages/Error Codes
A.1 Error Messages
Message
number
ED2A4
ED2A5
ED2A6
ED2A8
ED2A9
ED2AA
ED2AB
ED2AC
ED2AD
ED2AE
ED2AF
ED2B0
ED2B1
ED2B2
ED2B3
ED2B4
ED2B5
ED2B6
The specified Role name has already been used.
The specified Role name has already been used.
The number of roles has reached the maximum number of registrations.
The number of roles has reached the maximum number of registrations.
Deletion of a role that is assigned to a user is attempted.
Deletion of a role that is assigned to a user is attempted.
The specified Snap Data Pool Volume does not exist.
The specified SDPV does not exist.
The Copy Bitmap is insufficient.
All of the Copy Bitmap has been used.
Processing was interrupted because it reached max copy session count or copy function is not enable.
The number of sessions exceeds the maximum number for operation.
The specified volume is in process of copy session or RAID Migration.
A session is running for the specified LU.
An invalid LU is specified.
An invalid LU is specified.
Because specified session is not the oldest one, the processing was not performed.
The session is not in the correct status (a generation that is not the oldest is specified).
The specified volume is being initialized.
The specified SDV is being initialized.
The encryption settings of the copy source and the copy destination are different.
The encryption settings of the copy source and the copy destination are different.
The drive motor is stopped for either the copy source or the copy destination due to an Eco-mode sched-
ule.
The drive motor is stopped for either the copy source or the copy destination due to an Eco-mode sched-
ule.
The specified destination volume is being used by another session.
A copy scope overlap occurs in the specified SDV.
The Thin Provisioning function is disabled.
The Thin Provisioning function is disabled.
Slave CM: Execution was discontinued for the other command accepted.
In the Slave CM, the configuration management received a command because a passage occurs (this is
an error).
Slave CM: Error occurred in receiving data from Master CM.
In the Slave CM, a reception error occurred during communication between the CMs for receiving the
response from the master CM.
Master CM: Error occurred in sending data from Slave CM.
In the Master CM, a transmission error occurred during communication between the CMs for obtaining
command data from the Slave CM.
Master CM: Error occurred in receiving data from Slave CM.
In the Master CM, a reception error occurred during communication between the CMs for obtaining com-
mand data from the Slave CM.
ETERNUS CLI User's Guide
Copyright 2014 FUJITSU LIMITED
Message
Countermeasure for the error
874
P2X0-1210-05ENZ0