Baseline Ppp Interface - Juniper JUNOSE SOFTWARE 11.2.X - XML MANAGEMENT PROTOCOL GUIDE 6-30-2010 Command Reference Manual

baseline ppp interface

Syntax
Release Information
Description
Options
Mode
Copyright © 2010, Juniper Networks, Inc.
baseline ppp interface { atm | fastEthernet | gigabitEthernet | serial | mlppp | pos }
interfaceSpecifier
Command introduced before JunosE Release 7.1.0.
fastEthernet and gigabitEthernet keywords added in JunosE Release 11.0.0
Sets a statistics baseline for PPP interfaces. The router implements the baseline by
reading and storing the statistics at the time the baseline is set and then subtracting this
baseline whenever baseline-relative statistics are retrieved. There is no no version.
atm—Specifies an ATM interface
fastEthernet—Specifies a Fast Ethernet interface
gigabitEthernet—Specifies a Gigabit Ethernet interface
mlppp—Specifies an MLPPP interface
pos—Specifies a POS interface
serial—Specifies a serial interface
interfaceSpecifier—Particular interface; format varies according to interface type; see
Interface Types and Specifiers on page 5
Privileged Exec
Chapter 3: B Commands
259