Baseline Pppoe Interface - Juniper JUNOSE SOFTWARE 11.2.X - XML MANAGEMENT PROTOCOL GUIDE 6-30-2010 Command Reference Manual
Software for e series broadband services routers command reference a to m
Hide thumbs
Also See for JUNOSE SOFTWARE 11.2.X - XML MANAGEMENT PROTOCOL GUIDE 6-30-2010:
- Manual (282 pages)
Table of Contents
Advertisement
JunosE 11.2.x Command Reference Guide A to M
baseline pppoe interface
Syntax
Release Information
Description
Options
Mode
260
baseline pppoe interface interfaceType interfaceSpecifier
Command introduced before JunosE Release 7.1.0.
Sets a statistics baseline for PPPoE interfaces, subinterfaces, and/or circuits. The router
implements the baseline by reading and storing the statistics at the time the baseline is
set and then subtracting this baseline whenever baseline-relative statistics are retrieved.
There is no no version.
interfaceType—One of the following interface types listed in Interface Types and
Specifiers on page 5
atm
fastEthernet
gigabitEthernet
lag
serial—PPPoE is not currently supported on serial interfaces
tenGigabitEthernet
interfaceSpecifier—Particular interface; format varies according to interface type; see
Interface Types and Specifiers on page 5
Privileged Exec
Copyright © 2010, Juniper Networks, Inc.
Advertisement
Table of Contents
Need help?
Do you have a question about the JUNOSE SOFTWARE 11.2.X - XML MANAGEMENT PROTOCOL GUIDE 6-30-2010 and is the answer not in the manual?
Questions and answers