SST
Pin
CHARGING (1GR−FE)
−
REASSEMBLY
1.
INSTALL GENERATOR ROTOR ASSY
(a)
Place the drive end frame on the rotor.
(b)
Install the rotor and washer.
B17641
2.
INSTALL GENERATOR COIL ASSY
(a)
Using SST and a press, press in the coil carefully.
SST
(b)
Install the 4 bolts.
Torque: 5.8 N m (59 kgf cm, 51 in. lbf)
B17651
3.
INSTALL GENERATOR BRUSH HOLDER ASSY
(a)
Install the plate seal (Inside).
(b)
Place the brush holder with the pin facing upward.
NOTICE:
Be careful of the brush holder installing direction.
(c)
Install the 2 screws.
Torque: 1.8 N m (18 kgf cm, 16 in. lbf)
(d)
Align the pins of the brush holder with the holes of the
plate seal (outside), and install the plate seal (outside).
B17638
4.
INSTALL TERMINAL INSULATOR
B17637
5.
INSTALL GENERATOR REAR END COVER
(a)
Install the rear end cover with the 3 nuts.
Torque: 4.6 N m (47 kgf cm, 41 in. lbf)
B17636
GENERATOR
09285−76010
CH−13
CH0NB−01