Toyota Tundra 2005 Service - Repair - Maintenance page 2195

CH−14
Turn
Insert
Turn
SST (A)
SST (B)
Hold
CHARGING (1GR−FE)
SST (A)
SST (B)
Hold
B17632
SST (C)
B17633
B17657
Turn
B17635
− GENERATOR
6. INSTALL GENERATOR PULLEY
SST 09820−63011
(a) Install the pulley to the rotor shaft by tightening the pulley
nut by hand.
(b) Hold SST (A) with a torque wrench, and tighten SST (B)
clockwise with the specified torque.
Torque: 39 N m (400 kgf cm, 29 ft lbf)
NOTICE:
Check that SST is secured to the rotor shaft.
(c) Mount SST (C) in a vise.
(d) Insert SST (A) and (B) into SST (C), and attach the pulley
nut to SST (C)
(e) Tighten the pulley nut by turning SST (A) in the direction
shown in the illustration.
Torque: 111 N m (1,125 kgf cm, 81 ft lbf)
(f) Remove the generator from SST (C).
(g) Turn SST (B), and remove SST (A), (B).
(h) Turn the pulley, and check that the pulley moves smooth-
ly.