Toyota Tundra 2005 Service - Repair - Maintenance page 2192

SST
Hold
SST
Pulley
SST
CHARGING (1GR−FE)
REPLACEMENT
1. INSPECT GENERATOR ROTOR BEARING
(a) Check the bearing is not rough or worn.
If necessary, replace the bearing.
B17643
2. REMOVE GENERATOR ROTOR BEARING
SST
Turn
NOTICE:
Be careful not to damage the fan.
(a) Remove the bearing cover (Inside).
B17644
3. INSTALL GENERATOR ROTOR BEARING
(a) Place the rotor on the pulley.
(b) Install the bearing cover (Inside).
(c) Using SST and a press, press in a new bearing.
SST
B17645
(d) Using SST, push in the bearing cover (outside).
SST
B17646
4. INSPECT GENERATOR DRIVE END FRAME BEARING
(a) Check the bearing is not rough or worn.
If necessary, replace the bearing.
B17647
− GENERATOR
09820−00021
09820−00031
09285−76010
CH−11
CH0NA−01