SST (B)
SST (C)
Insert
SST (C)
Turn
Turn
SST (B)
SST
CHARGING (2UZ−FE)
(c)
Mount SST (C) in a vise.
(d)
Insert SST (B) into SST (C), and attach the pulley nut to
SST (C).
P10834
(e)
To loosen the pulley nut, turn SST (A) in the direction
shown in the illustration.
NOTICE:
To prevent damage to the rotor shaft, do not loosen the
SST (A)
pulley nut more than one−half of a turn.
(f)
Remove the generator from SST (C).
P10827
(g)
Turn SST (B), and remove SST (A and B).
(h)
Remove the pulley nut and pulley.
SST (A)
P13598
5.
REMOVE RECTIFIER END FRAME
(a)
Remove the 4 nuts.
B16527
(b)
Using SST, remove the rectifier end frame.
SST
(c)
Remove the generator washer from the rectifier end
frame.
6.
REMOVE ROTOR FROM DRIVE END FRAME
B04568
−
GENERATOR (Standard Spec.)
09286−46011
CH−9