Block %2 Illegal Retract Plane With Wab; Block %2 Overflow Of Local Block Buffer Due To Orientation Smoothing; Block %2 Plane Change During Linear Programming With Angles; Block %2 Invalid Angle During Linear Programming - Siemens Sinamics S120 Diagnostic Manual

10748 [Channel %1: ] Block %2 illegal retract plane with WAB
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: By means of DISRP a position of the retraction plane has been programmed which is not situated between the safety
distance (DISCL) and the starting point (during approach) and/or end point (during retraction) of the WAB movement.
Reaction: Correction block is reorganized.
Local alarm reaction.
Interface signals are set.
Alarm display.
NC Stop on alarm at block end.
Remedy: Modify part program
Program Clear alarm with NC START or RESET key and continue the program.
Continuation:
10771 [Channel %1: ] Block %2 overflow of local block buffer due to orientation smoothing
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: This error occurs when more blocks must be buffered than memory space is available.
This error can only occur when the software has been incorrectly configured.
Reaction: Correction block is reorganized.
Local alarm reaction.
Interface signals are set.
Alarm display.
Remedy: Increase size of local buffer area.
Program Clear alarm with NC START or RESET key and continue the program.
Continuation:
10790 [Channel %1: ] Block %2 plane change during linear programming with angles
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: The active plane was changed between the first and second subblock when programming two straight lines with angle
parameters.
Reaction: Correction block is reorganized.
Local alarm reaction.
Interface signals are set.
Alarm display.
NC Stop on alarm at block end.
Remedy: Modify part program.
Program Clear alarm with NC START or RESET key and continue the program.
Continuation:
10791 [Channel %1: ] Block %2 invalid angle during linear programming
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: No intermediate point was found when programming a contour consisting of two straight lines and an angle specifica-
tion.
Alarms
Diagnostics Manual, 07/2010, 6FC5398-8BP40-0BA0
NCK alarms
91