Block %2: Infeed Too Small; Block %2: Number Of Edges Too Small; Block %2: Width Across Flats/Edge Length Too Small; Block %2: Width Across Flats/Edge Length Too Large - Siemens Sinamics S120 Diagnostic Manual

NCK alarms
Program Clear alarm with the RESET key. Restart part program
Continuation:
61248 [Channel %1: ] Block %2: Infeed too small
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: The infeed is too small for machining.
Alarm triggered by following cycle: CYCLE79.
Reaction: Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy: Increase infeed.
Program Clear alarm with the RESET key. Restart part program
Continuation:
61249 [Channel %1: ] Block %2: Number of edges too small
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: The number of edges is too small.
Alarm triggered by following cycle: CYCLE79.
Reaction: Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy: Increase number of edges.
Program Clear alarm with the RESET key. Restart part program
Continuation:
61250 [Channel %1: ] Block %2: Width across flats/edge length too small
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: The width across flats/edge length is too small.
Alarm triggered by following cycle: CYCLE79.
Reaction: Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy: Increase key width/edge length.
Program Clear alarm with the RESET key. Restart part program
Continuation:
61251 [Channel %1: ] Block %2: Width across flats/edge length too large
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: The width across flats/edge length is too large.
Alarm triggered by following cycle: CYCLE79.
416
Diagnostics Manual, 07/2010, 6FC5398-8BP40-0BA0
Alarms