Block %2: No Swiveling In Jog; Block %2: Swiveling - Plane Not Allowed; Block %2: Swiveling With Kinematic Chain; Block %2: Swiveling - Tool Not Allowed - Siemens Sinamics S120 Diagnostic Manual

NCK alarms
Program Clear alarm with the RESET key. Restart part program
Continuation:
61196 [Channel %1: ] Block %2: No swiveling in JOG --> Multi-axis transformations and
TCARR activated at the same time
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: Multi-axis transformations (TRAORI) and Toolcarrier (TCARR) activated at the same time.
Alarm triggered by following cycles: CYCLE800.
Remedy: Deselection of multi-axis transformation with TRAFOOF
or deselection of Toolcarrier (TCARR) with CYCLE800()
61197 [Channel %1: ] Block %2: Swiveling - plane not allowed -> Error code %4
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: Alarm triggered by following cycles: CYCLE800.
Reaction: Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy: Error code:
Program Clear alarm with the RESET key. Restart part program
Continuation:
61198 [Channel %1: ] Block %2: Swiveling with kinematic chain -> Error code: %4
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: Alarm triggered by following cycles: CYCLE800.
Reaction: Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy: --
Program Clear alarm with the RESET key. Restart part program
Continuation:
61199 [Channel %1: ] Block %2: Swiveling - tool not allowed -> Error code: %4
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: See error code for error cause. Alarm triggered by following cycles: CYCLE800.
Reaction: Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy: Error code:
A: Orientation of tool and change of swivel data record not allowed
402
Diagnostics Manual, 07/2010, 6FC5398-8BP40-0BA0
Alarms