Block %2 Start Tangent For Orientation Is Zero; Block %2 Programmed Rotation Is Not Possible; Block %2 Oripath Lift Factor Impermissible; Block %2 Rotation Programmed Several Times - Siemens Sinamics S120 Diagnostic Manual
Hide thumbs
Also See for Sinamics S120:
- Function manual (1094 pages) ,
- Manual (848 pages) ,
- Equipment manual (570 pages)
Table of Contents
Advertisement
NCK alarms
14124
[Channel %1: ] Block %2 start tangent for orientation is zero
Parameters:
%1 = Channel number
%2 = Block number, label
Definitions:
With taper circumference interpolation with tangential continuation (ORICONTO), the start tangent of orientation must
not be zero.
Reaction:
Correction block is reorganized.
Interface signals are set.
Alarm display.
Remedy:
Modify part program.
Program
Clear alarm with NC START or RESET key and continue the program.
Continuation:
14125
[Channel %1: ] Block %2 programmed rotation is not possible
Parameters:
%1 = Channel number
%2 = Block number, label
Definitions:
The programmed rotation of tool orientation cannot be traversed.
Reaction:
Correction block is reorganized.
Interface signals are set.
Alarm display.
Remedy:
Modify part program.
Program
Clear alarm with NC START or RESET key and continue the program.
Continuation:
14126
[Channel %1: ] Block %2 ORIPATH lift factor impermissible.
Parameters:
%1 = Channel number
%2 = Block number, label
Definitions:
The value programmed with ORIPLF = r is not within the permissible range. The relative retraction factor must lie within
interval 0 <= r < 1.
Reaction:
Correction block is reorganized.
Interpreter stop
Interface signals are set.
Alarm display.
Remedy:
Modify part program.
Program
Clear alarm with NC START or RESET key and continue the program.
Continuation:
14127
[Channel %1: ] Block %2 rotation programmed several times
Parameters:
%1 = Channel number
%2 = Block number, label
Definitions:
The rotation (3rd degree of freedom of orientation at 6-axis transformations) has been programmed several times.
The rotation is clearly defined by one of the following specifications:
- Specification of the rotary axis positions included in the transformation
- Specification of Euler or RPY angles (A2, B2, C2)
- Specification of the normal orientation vector (AN3, BN3, CN3)
- Specification of the THETA angle of rotation
162
Diagnostics Manual, 07/2010, 6FC5398-8BP40-0BA0
Alarms
Hide quick links:
Advertisement
Table of Contents
