Block %2 Pole Angle Too Large; Block %2 Pole Programmed Incorrectly; Block %2 Polar Coordinates Programmed Incorrectly - Siemens Sinamics S120 Diagnostic Manual

Remedy: Correct the NC part program. Permissible inputs for the pole radius are only positive, absolute values that specify the
distance between the reference point and the new pole. (The direction is defined with the pole angle AP=...).
Program Clear alarm with NC START or RESET key and continue the program.
Continuation:
14260 [Channel %1: ] Block %2 pole angle too large
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: In redefining the pole with G110, G111 or G112 in polar coordinates, the value range of the pole angle specified under
keyword AP=... has been exceeded. It covers the range from -360 to +360 degrees with a resolution of 0.001 degrees.
Definition of terms:
- Specification of end of block point with polar angle and polar radius, referring to the current pole (preparatory func-
tions: G00/G01/G02/G03).
- New definition of the pole with polar angle and pole radius, referring to the reference point selected with the G func-
tion. G110 ... last programmed point in the plane, G111 ... zero point of the current work, G112 ... last pole
Reaction: Correction block is reorganized.
Interface signals are set.
Alarm display.
Remedy: Correct NC part program. The permissible input range for the polar angle is between the values -360 degrees and
+360 degrees with a resolution of 0.001 degrees.
Program Clear alarm with NC START or RESET key and continue the program.
Continuation:
14270 [Channel %1: ] Block %2 pole programmed incorrectly
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: When defining the pole, an axis was programmed that does not belong to the selected processing level. Programming
in polar coordinates always refers to the plane activated with G17 to G19. This also applies to the definition of a new
pole with G110, G111 or G112.
Reaction: Correction block is reorganized.
Interface signals are set.
Alarm display.
Remedy: Correct the NC part program. Only the two geometry axes may be programmed that establish the current machining
plane.
Program Clear alarm with NC START or RESET key and continue the program.
Continuation:
14280 [Channel %1: ] Block %2 polar coordinates programmed incorrectly
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: The end point of the displayed block has been programmed both in the polar coordinate system (with AP=..., RP=...)
and in the Cartesian coordinate system (axis addresses X, Y,...).
Reaction: Correction block is reorganized.
Interface signals are set.
Alarm display.
Remedy: Correct the NC part program - the axis motion may be specified in one coordinate system only.
Program Clear alarm with NC START or RESET key and continue the program.
Continuation:
Alarms
Diagnostics Manual, 07/2010, 6FC5398-8BP40-0BA0
NCK alarms
177