Block %2 Non-Active Function Used (Identification %3); Block %2 Coordinate System-Specific Working Area Limitation Is Not - Siemens Sinamics S120 Diagnostic Manual

NCK alarms
25
26
27
33
34
35
36
37
41
42
45
46
47
48
49
50
Reaction: Correction block is reorganized.
Interface signals are set.
Alarm display.
Remedy: Modify part program, retrofit option.
Program Clear alarm with NC START or RESET key and continue the program.
Continuation:
14782 [Channel %1: ] Block %2 non-active function used (identification %3)
Parameters: %1 = Channel number
%2 = Block number, label
%3 = Fine ID
Definitions: A non-active function is used in the block
Brief description of the identification
1
2
Reaction: Correction block is reorganized.
Interface signals are set.
Alarm display.
Remedy: - Modify part program.
- Activate function.
Program Clear alarm with NC START or RESET key and continue the program.
Continuation:
14783 [Channel %1: ] Block %2 coordinate system-specific working area limitation is not
active
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: An attempt is made in the block to activate a group of the coordinate system-specific working area limitation.
However, this group is not set up (see MD28600 $MC_MM_NUM_WORKAREA_CS_GROUPS).
Reaction: Correction block is reorganized.
Interface signals are set.
Alarm display.
The NC program is stopped. The G code of the group WALCS01 - WALCS10 can be changed.
Remedy: - Modify part programm.
- Activate more coordinate system-specific working area limitations.
Program Clear alarm with NC START or RESET key and continue the program.
Continuation:
198
TechCycle option
Liftfast option
ProgAccel option
AllAsupSynact option
CmdAxSpind option
Mea2 option
ProgAnaOut option
OptAaTOff option
MachineMaintenance option
PathFeedSAInput option
ElecTransfer option
Cut3D option
CDA option
Reserved: generic coupling option
Measuring cycles option
ForceControl option
Transformation
H number of the tool
Diagnostics Manual, 07/2010, 6FC5398-8BP40-0BA0
Alarms