Block %2 Overlaid Handwheel Motion Activated Incorrectly; Axis %4: Handwheel %1 Used Twice (%2) - Siemens Sinamics S120 Diagnostic Manual

NCK alarms
14290 [Channel %1: ] Block %2 polynominal degree greater than 5 programmed for
polynominal interpolation
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: A polynominal degree greater than five was programmed for the polynominal interpolation. You can only program poly-
nomials up to the 5th degree.
Reaction: Correction block is reorganized.
Interface signals are set.
Alarm display.
Remedy: Modify part program.
Program Clear alarm with NC START or RESET key and continue the program.
Continuation:
14300 [Channel %1: ] Block %2 overlaid handwheel motion activated incorrectly
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: Handwheel override has been called up incorrectly:
- 1st For positioning axes:
- Handwheel override programmed for indexing axes,
- No position programmed,
- FA and FDA programmed for the same axis in the block.
- 2nd For contouring axes:
- No position programmed,
- G60 not active,
- 1st G group incorrect (only G01 to CIP).
Reaction: Correction block is reorganized.
Interface signals are set.
Alarm display.
Remedy: Modify part program.
Program Clear alarm with NC START or RESET key and continue the program.
Continuation:
14320 [Channel %3: ] Axis %4: handwheel %1 used twice (%2)
Parameters: %1 = Handwheel number
%2 = Use
%3 = Channel
%4 = Axis
Definitions: Informational alarm indicating that the mentioned handwheel is used twice:
The second parameter provides the explanation:
1: Block with axial handwheel override for this axis cannot be executed as the handwheel
for this axis performs a DRF movement
2: Block with velocity override of the path cannot be executed as the handwheel performs
a DRF movement for this axis of the path
3: Block with contour handwheel cannot be executed as the handwheel performs a DRF movement
for this axis of the path
4: PLC axis with axial handwheel override cannot be started immediately as the handwheel performs
a DRF movement for this axis
5: The axis is a reciprocating axis with axial handwheel override; the reciprocating movement cannot be
started immediately as the handwheel performs a DRF movement for this axis
6: The DRF movement for this axis cannot be executed as an axial handwheel override is active for
this axis with the handwheel
178
Diagnostics Manual, 07/2010, 6FC5398-8BP40-0BA0
Alarms