RB-6 L-801A (Airport) Rotating Beacon (Export)
Replacing Brushes and Brush
Brackets
5
4
3
Figure 4-1. Brush Block Assembly
1. Brush Block Assembly
2. Brass Hex Nut
3. Hex Nut and Lockwasher
2001 Siemens Airfield Solutions, Incorporated
All rights reserved
Replace all three brushes at the same time to provide even wear.
To replace the brushes and brush brackets, perform the following
procedure:
1. See Figure 4-1. Remove the two screws, lockwashers, and hex nuts
holding the brush block assembly (1) to the motor box.
1
2
Side View
4. Brush Block Screw
5. Wire
6. Brush Screw
1
6
8
7
Side View of Bracket
7. Brush
8. Brush Bracket
9. Drive Pint
96A0221B
Issued 5/01
Maintenance
Front View
2
9
Page 4-3