Block %2: Tool Radius Too Large; Block %2: No Tool Active; Block %2: Plane Infeed Greater Than Tool Diameter - Siemens Sinamics S120 Diagnostic Manual
Hide thumbs
Also See for Sinamics S120:
- Function manual (1094 pages) ,
- Manual (848 pages) ,
- Equipment manual (570 pages)
Table of Contents
Advertisement
NCK alarms
Remedy:
Enter the number of teeth on the milling tool in the "Tool list" menu.
Program
Clear alarm with the RESET key. Restart part program
Continuation:
61219
[Channel %1: ] Block %2: Tool radius too large
Parameters:
%1 = Channel number
%2 = Block number, label
Definitions:
The tool radius is too large for machining.
Reaction:
Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy:
Select a suitable tool.
Program
Clear alarm with the RESET key. Restart part program
Continuation:
61220
[Channel %1: ] Block %2: Tool radius too small
Parameters:
%1 = Channel number
%2 = Block number, label
Definitions:
The tool radius is too small for machining.
Alarm triggered by following cycles: CYCLE78.
Reaction:
Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy:
Select a suitable tool.
Program
Clear alarm with the RESET key. Restart part program
Continuation:
61221
[Channel %1: ] Block %2: No tool active
Parameters:
%1 = Channel number
%2 = Block number, label
Definitions:
No tool active.
Reaction:
Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy:
Select a suitable tool.
Program
Clear alarm with the RESET key. Restart part program
Continuation:
61222
[Channel %1: ] Block %2: Plane infeed greater than tool diameter
Parameters:
%1 = Channel number
%2 = Block number, label
Definitions:
The plane infeed must not be greater than the tool diameter.
Alarm triggered by following cycles: CYCLE79, , E_MI_PL, E_PO_CIR, E_PO_REC, F_PO_CIR, F_PO_REC.
408
Diagnostics Manual, 07/2010, 6FC5398-8BP40-0BA0
Alarms
Hide quick links:
Advertisement
Table of Contents
