Block %2: Active Tool Violates Programmed Contour; Block %2: Contour Incorrectly Programmed; Block %2: Error During Contour Preparation; Block %2: Starting Point Incorrectly Programmed - Siemens Sinamics S120 Diagnostic Manual

NCK alarms
61604 [Channel %1: ] Block %2: Active tool violates programmed contour
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: Contour violation in the relief cut elements due to the tool clearance angle of the tool used. Alarm triggered by following
cycle: CYCLE95.
Reaction: Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy: Use a different tool or check the contour subroutine.
Program Clear alarm with the RESET key. Restart part program
Continuation:
61605 [Channel %1: ] Block %2: Contour incorrectly programmed
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: Illegal relief cut element detected. Alarm triggered by following cycles: CYCLE76, CYCLE77, CYCLE95.
Remedy: Check contour program.
Program Clear alarm with the RESET key. Restart part program
Continuation:
61606 [Channel %1: ] Block %2: Error during contour preparation
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: An error has been found on conditioning the contour. This alarm is always related to one of NCK alarms
10930...10934, 15800 or 15810. Alarm triggered by following cycle: CYCLE95.
Remedy: Check contour subroutine.
Program Clear alarm with the RESET key. Restart part program
Continuation:
61607 [Channel %1: ] Block %2: Starting point incorrectly programmed
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: The starting point reached before the cycle call does not lie outside the rectangle described by the contour subroutine.
Alarm triggered by following cycle: CYCLE95.
Remedy: Check starting point prior to cycle call.
Program Clear alarm with the RESET key. Restart part program
Continuation:
464
Diagnostics Manual, 07/2010, 6FC5398-8BP40-0BA0
Alarms