Block %2 No Angle Or Direction Of The Cone Programmmed; Block %2 No End Orientation Programmed; Block %2 No Intermediate Orientation Programmed; Block %2 Plane Determination For Programmed Orientation Not Possible - Siemens Sinamics S120 Diagnostic Manual
Hide thumbs
Also See for Sinamics S120:
- Function manual (1094 pages) ,
- Manual (848 pages) ,
- Equipment manual (570 pages)
Table of Contents
Advertisement
NCK alarms
14117
[Channel %1: ] Block %2 no angle or direction of the cone programmmed
Parameters:
%1 = Channel number
%2 = Block number, label
Definitions:
With taper circumference interpolation of orientation (ORICONCW and ORICONCC), either the opening angle or the
direction vector of the taper must be programmed. Otherwise, the change of orientation is not clearly defined.
Reaction:
Correction block is reorganized.
Interface signals are set.
Alarm display.
Remedy:
Modify part program.
Program
Clear alarm with NC START or RESET key and continue the program.
Continuation:
14118
[Channel %1: ] Block %2 no end orientation programmed
Parameters:
%1 = Channel number
%2 = Block number, label
Definitions:
With taper circumference interpolation of orientation, no end orientation has been programmed. The change of orien-
tation is therefore not clearly defined.
Reaction:
Correction block is reorganized.
Interface signals are set.
Alarm display.
Remedy:
Modify part program.
Program
Clear alarm with NC START or RESET key and continue the program.
Continuation:
14119
[Channel %1: ] Block %2 no intermediate orientation programmed
Parameters:
%1 = Channel number
%2 = Block number, label
Definitions:
With taper circumference interpolation of orientation with ORICONIO, an intermediate orientation must also be pro-
grammed in addition to the end orientation.
Reaction:
Correction block is reorganized.
Interface signals are set.
Alarm display.
Remedy:
Modify part program.
Program
Clear alarm with NC START or RESET key and continue the program.
Continuation:
14120
[Channel %1: ] Block %2 plane determination for programmed orientation not possible
Parameters:
%1 = Channel number
%2 = Block number, label
Definitions:
The programmed orientation vectors (direction vectors) in the beginning of block and end of block point include an
angle of 180 degrees. Therefore the interpolation plane cannot be determined.
Example:
N50 TRAORI (1)
N55 A3=0 B3=0 C3=1
N60 A3=0 B3=0 C3=-1 ; the vector of this block is precisely opposite to that in the preceding block.
Reaction:
Correction block is reorganized.
Interface signals are set.
Alarm display.
160
Diagnostics Manual, 07/2010, 6FC5398-8BP40-0BA0
Alarms
Hide quick links:
Advertisement
Table of Contents
