Programming Of Inch/Metric Measuring System Not Allowed Here; G0 Is Not Allowed In Contour Programming; Pocket Depth Programmed Incorrectly; No Starting Point Specified - Siemens Sinamics S120 Diagnostic Manual
Hide thumbs
Also See for Sinamics S120:
- Function manual (1094 pages) ,
- Manual (848 pages) ,
- Equipment manual (570 pages)
Table of Contents
Advertisement
NCK alarms
61935
%[[Channel %1: ] Block %2: %]Programming of inch/metric measuring system not
allowed here
Parameters:
%1 = Channel number
%2 = Block number, label
Definitions:
Alarm triggered by following cycles: CYCLE63, CYCLE64
Reaction:
Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy:
- Modify contour programming
Program
Clear alarm with the RESET key. Restart part program
Continuation:
61936
%[[Channel %1: ] Block %2: %]G0 is not allowed in contour programming
Parameters:
%1 = Channel number
%2 = Block number, label
Definitions:
Alarm triggered by following cycles: CYCLE63, CYCLE64
Reaction:
Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy:
- Modify contour programming, replace G0 by G1
Program
Clear alarm with the RESET key. Restart part program
Continuation:
61937
%[[Channel %1: ] Block %2: %]Pocket depth programmed incorrectly
Parameters:
%1 = Channel number
%2 = Block number, label
Definitions:
Alarm triggered by following cycles: CYCLE63
Reaction:
Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy:
- Check parameter Z1
Program
Clear alarm with the RESET key. Restart part program
Continuation:
61938
%[[Channel %1: ] Block %2: %]No starting point specified
Parameters:
%1 = Channel number
%2 = Block number, label
Definitions:
Alarm triggered by following cycles: CYCLE63
Reaction:
Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
486
Diagnostics Manual, 07/2010, 6FC5398-8BP40-0BA0
Alarms
Hide quick links:
Advertisement
Table of Contents
