Block %2: Modify Tool Tip Position; Block %2: Check Calibration Block Number; Block %2: Check Safety Area/Block %2: Reserved; Block %2: Geometry Axes Do Not Exist - Siemens Sinamics S120 Diagnostic Manual

61332 [Channel %1: ] Block %2: Modify tool tip position
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: The tool tip is below the measuring probe surface (e.g. for a ring gauge or cube). Alarm is triggered: CYCLE971,
CYLCE972, CYCLE982, E_MT_CAL, E_MT_LEN, E_MT_RAD.
Remedy: Place the tool above the measuring probe surface.
61333 [Channel %1: ] Block %2: Check calibration block number
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: Alarm triggered: CYCLE973
Remedy: Parameter _CALNUM is too large, reduce it to a permissible value
For 840D:
- Increase the maximum value of _CVAL[2] in GUD6
For 840D sl:
- Check following machine data: 51601 $MNS_MEA_CAL_EDGE_NUM
61334 [Channel %1: ] Block %2: Check safety area
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: Alarm triggered: CYCLE977
Remedy: Check the parameters for the safety area
For 840D: _SZA or _SZO
For 840D sl: XS, YS or ZS
61335 [Channel %1: ] Block %2: Reserved
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: Alarm triggered: Reserved
Remedy: reserved
61336 [Channel %1: ] Block %2: Geometry axes do not exist
Parameters: %1 = Channel number
%2 = Block number, label channel number
Definitions: No geometry axes configured. Alarm can be triggered by following measuring cycles: all measuring cycles.
Remedy: Machine data in MD 20060 must be changed.
Alarms
Diagnostics Manual, 07/2010, 6FC5398-8BP40-0BA0
NCK alarms
437