Block %2 Analog Input No. %3 Not Activated; Block %2 Analog Output No. %3 Not Activated; Block %2 Nck Output %3 Is Assigned To A Function Via Machine Data; Block %2 Maximum Of %3 Nck Outputs Programmable In The Block - Siemens Sinamics S120 Diagnostic Manual

17120 [Channel %1: ] Block %2 analog input no. %3 not activated
Parameters: %1 = Channel number
%2 = Block number, label
%3 = Input number
Definitions: An attempt has been made by means of the system variable $A_INA[n] to read an analog input n that has not been
activated by the MD10300 $MN_FASTIO_ANA_NUM_INPUTS.
Reaction: Correction block is reorganized.
Interface signals are set.
Alarm display.
Remedy: Please inform the authorized personnel/service department. Modify part program or machine data accordingly.
Program Clear alarm with NC START or RESET key and continue the program.
Continuation:
17130 [Channel %1: ] Block %2 analog output no. %3 not activated
Parameters: %1 = Channel number
%2 = Block number, label
%3 = No. of output
Definitions: An attempt has been made by means of the system variable $A_OUTA[n] to write or read an analog output n that has
not been activated by the MD10310 $MN_FASTIO_ANA_NUM_OUTPUTS.
Reaction: Correction block is reorganized.
Interface signals are set.
Alarm display.
Remedy: Please inform the authorized personnel/service department. Modify part program or machine data accordingly.
Program Clear alarm with NC START or RESET key and continue the program.
Continuation:
17140 [Channel %1: ] Block %2 NCK output %3 is assigned to a function via machine data
Parameters: %1 = Channel number
%2 = Block number, label
%3 = No. of output
Definitions: The programmed digital/analog output is assigned to an NC function (e.g. software cams).
Reaction: Correction block is reorganized.
Interface signals are set.
Alarm display.
Remedy: Please inform the authorized personnel/service department. Use another output or deactivate concurrent NC function
via MD.
Program Clear alarm with NC START or RESET key and continue the program.
Continuation:
17150 [Channel %1: ] Block %2 maximum of %3 NCK outputs programmable in the block
Parameters: %1 = Channel number
%2 = Block number, label
%3 = Quantity
Definitions: No more than the specified number of outputs may be programmed in an NC block.
The quantity of hardware outputs is defined in the MDs:
MD10360 $MN_FASTIO_DIG_NUM_OUTPUTS and
MD10310 $MN_FASTIO_ANA_NUM_OUTPUTS
Alarms
Diagnostics Manual, 07/2010, 6FC5398-8BP40-0BA0
NCK alarms
271