Block %2 Error In Definition Of Channel-Specific Protection Zone %3; Block %2 Invalid Value Assigned To Fxs; Block %2 Invalid Value Assigned To Fxst; Block %2 Invalid Value Assigned To Fxsw - Siemens Sinamics S120 Diagnostic Manual

NCK alarms
18006 [Channel %1: ] Block %2 serious error in definition of channel-specific protection zone
%3
Parameters: %1 = Channel number
%2 = Block number, label
%3 = Protection zone number
Definitions: The protection zone definition must be terminated with EXECUTE before a preprocessing stop is performed. This also
applies to any that are initiated implicitly such as with G74, M30, M17.
Reaction: Correction block is reorganized.
Local alarm reaction.
Interface signals are set.
Alarm display.
Remedy: Modify part program.
Program Clear alarm with NC START or RESET key and continue the program.
Continuation:
18100 [Channel %1: ] Block %2 invalid value assigned to FXS[]
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: The following values are valid at the present time:
0: "Deselect traverse against fixed stop"
1: "Select traverse against fixed stop" valid.
Reaction: Correction block is reorganized.
Interface signals are set.
Alarm display.
Remedy: --
Program Clear alarm with NC START or RESET key and continue the program.
Continuation:
18101 [Channel %1: ] Block %2 invalid value assigned to FXST[]
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: Only the range 0.0 - 100.0 is valid at the present time.
Reaction: Correction block is reorganized.
Interface signals are set.
Alarm display.
Remedy: --
Program Clear alarm with NC START or RESET key and continue the program.
Continuation:
18102 [Channel %1: ] Block %2 invalid value assigned to FXSW[]
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: Only positive values including zero are valid at the present time.
Reaction: Correction block is reorganized.
Interface signals are set.
Alarm display.
Remedy: --
294
Diagnostics Manual, 07/2010, 6FC5398-8BP40-0BA0
Alarms