Siemens Sinamics S120 Diagnostic Manual page 912

List of actions
/SINGLEAX_JOG_PLUS_INC_MASTER/ No. 113
Definitions: Available soon
/SINGLEAX_JOG_MINUS_INC_MASTER/ No. 114
Definitions: Available soon
/REPOSMODECHANGE/ No. 115
Definitions: The event is triggered by the positive PLC edge of the
signal "Repos mode edge".
Not permitted if:
1. The channel is active (program running, block search, loading machine data)
Possible actions:
1. Cancel the program with the Reset button
or stop the program (not with block search, loading machine data)
/TOOLCHANGECMDON/ No. 116
Definitions: Enable the tool management commands.
(CH VDI signal)
Not permitted if:
1. The NCK channel status is not Ready
Possible actions:
1. Cancel program or process with reset button
/TOOLCHANGECMDOFF/ No. 117
Definitions: Disable the tool management commands.
(CH VDI signal)
Not permitted if:
1. The NCK channel status is not Ready
Possible actions:
1. Cancel program or process with reset button
/SIVLIMCHANGE/ No. 118
Definitions: Switching over the desired safety limits (SGE)
is always permitted
912
or wait for end of program
or wait for end of program
Diagnostics Manual, 07/2010, 6FC5398-8BP40-0BA0
Alarms