Spindle %2 Fc18 Function Not Possible (Cause: Error Code %3); Block %2 Putftocf Command Could Not Be Transferred; Axis %2 Preset Not Allowed During Traverse Motion - Siemens Sinamics S120 Diagnostic Manual

NCK alarms
22297 [Channel %1: ] Spindle %2 FC18 function not possible (cause: error code %3)
Parameters: %1 = Channel number
%2 = Axis name, spindle number
%3 = Error code
Definitions: The function request by PLC via FC18 interface could not be executed. The cause is specified by the error code.
Error codes:
- Error code 1 : internal use
- Error code 2 : internal use
- Error code 3 : internal use
- Error code 4 : internal use
- Error code 5 : Switchover to command axis not possible
- Error code 6 : Switchover to PLC axis not possible
- Error code 20 : internal use
- Error code 21 : internal use
- Error code 22 : internal use
- Error code 23 : MD 30132 IS_VIRTUAL_AX has been set
- Error code 50 : internal use
- Error code 51 : internal use
- Error code 70 : internal use
Reaction: NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy: Remedy conflict.
Program Clear alarm with the Delete key or NC START.
Continuation:
22320 [Channel %1: ] Block %2 PUTFTOCF command could not be transferred
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: The cyclic transfer of the PUTFTOCF data block (fine tool compensation) could not be performed because the transfer
area is already occupied.
Reaction: Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
NC Stop on alarm.
Remedy: Check the part program, in particular with regard to the other channels. Is a data block being transferred by another
channel?
Program Clear alarm with the RESET key. Restart part program
Continuation:
22321 [Channel %1: ] Axis %2 PRESET not allowed during traverse motion
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: A preset command was sent from the HMI or PLC while an axis was traveling in JOG mode.
Reaction: Interface signals are set.
Alarm display.
Remedy: Wait until the axis is stationary.
Program Clear alarm with the Delete key or NC START.
Continuation:
344
Diagnostics Manual, 07/2010, 6FC5398-8BP40-0BA0
Alarms