Block %2 : Angle Adapted To Angle Grid: %4; No Swiveling In Jog - Wo G%4 Active, Total Basic Wo Contain Rotations; Block %2: Start Spindle; Block %2: Z Offset Does Not Influence The Retraction Planes - Siemens Sinamics S120 Diagnostic Manual

NCK alarms
62185 [Channel %1: ] Block %2 : angle adapted to angle grid: %4
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: %4 difference angle with Hirth tooth system
Alarm triggered by following cycle: CYCLE800.
Remedy: Check setup of swivel CYCLE800.
62186 [Channel %1: ] Block %2: No swiveling in JOG -> WO G%4 active and total basic WO
(G500) contain rotations
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: Alarm triggered by following cycle: CYCLE800.
On swiveling in JOG no rotation can be written to the work offset WO,
if rotations are already contained in the total basic WO or in the basic reference
Error 62186 message can be masked -> see setting data 55410 $SCS_MILL_SWIVEL_ALARM_MASK
Remedy: %4 number of the active work offset WO.
62187 [Channel %1: ] Block %2: Swiveling in JOG --> G500 active and total basic WO or basic
reference contain rotations
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: Alarm triggered by following cycle: CYCLE800.
During swiveling in JOG, it is not possible to write a rotation into the work offset WO,
if, with active G500, rotations are already contained in the total basic WO or in the basic reference
Error message 62187 can be masked -> see setting data 55410 $SCS_MILL_SWIVEL_ALARM_MASK
Remedy: See notes for 62186 and 62187.
62200 [Channel %1: ] Block %2: Start spindle
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: Stop prior to thread machining, as the spindle is in stop position.
Alarm triggered by following cycles: ASUP, E_TR_CON, F_TR_CON.
Remedy: Start the tool spindle before machining the thread.
62201 [Channel %1: ] Block %2: Z offset does not influence the retraction planes.
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: The retraction planes refer to the workpiece. Therefore, programmable offsets do not influence the retraction planes.
Alarm triggered by following cycle: F_SP_RP.
Remedy: Ensure that the offset will not cause a collision.
Then start the NC.
The alarm can be suppressed via display machine data 9898.
494
Diagnostics Manual, 07/2010, 6FC5398-8BP40-0BA0
Alarms