Block %2: No Work Offset Entered For Main Spindle; Block %2: No Work Offset Entered For Counterspindle; Block %2: Probe Defective - Siemens Sinamics S120 Diagnostic Manual

NCK alarms
Reaction: Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy: Program the retraction plane in absolute terms.
Program Clear alarm with the RESET key. Restart part program
Continuation:
61298 [Channel %1: ] Block %2: No work offset entered for main spindle
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: The alarm is triggered by the following cycles: F_SUB_SP
No work offset has been specified for the main spindle.
Reaction: Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy: Specify a work offset for the main spindle in the program header or under Settings.
Program Clear alarm with the RESET key. Restart part program
Continuation:
61299 [Channel %1: ] Block %2: No work offset entered for counterspindle
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: The alarm is triggered by the following cycles: F_SUB_SP
No work offset has been entered for the counterspindle.
Reaction: Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy: Specify a work offset for the counterspindle in the program header or under Settings.
Program Clear alarm with the RESET key. Restart part program
Continuation:
61300 [Channel %1: ] Block %2: Probe defective
Parameters: %1 = Channel number
%2 = Block number, label
Definitions:
Reaction: Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy:
Program Clear alarm with the RESET key. Restart part program
Continuation:
430
Diagnostics Manual, 07/2010, 6FC5398-8BP40-0BA0
Alarms