Block %2 Search Target Not Found; Illegal Target Of Block Search (Syntax Error); Target Of Block Search Not Found; Block %2 Illegal Incremental Programming In Axis %3 - Siemens Sinamics S120 Diagnostic Manual
Hide thumbs
Also See for Sinamics S120:
- Function manual (1094 pages) ,
- Manual (848 pages) ,
- Equipment manual (570 pages)
Table of Contents
Advertisement
Remedy:
Repeat the input with corrected label.
Program
Clear alarm with the Delete key or NC START.
Continuation:
15350
[Channel %1: ] Block %2 search target not found
Parameters:
%1 = Channel number
%2 = Block number, label
Definitions:
The specified program has been searched to the end of the program without the selected search target having been
found.
Reaction:
Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy:
Check the part program, change the block search (typing error in the part program) and restart the search.
Program
Clear alarm with the RESET key. Restart part program
Continuation:
15360
[Channel %1: ] Illegal target of block search (syntax error)
Parameters:
%1 = Channel number
Definitions:
The specified search target (block number, label or string) is not allowed in block search.
Reaction:
Alarm display.
Remedy:
Correct target of block search.
Program
Clear alarm with the Delete key or NC START.
Continuation:
15370
[Channel %1: ] Target of block search not found
Parameters:
%1 = Channel number
Definitions:
In a block search, an impermissible search target has been specified (e.g. negative block number).
Reaction:
Alarm display.
Remedy:
Check the specified block number, label or character string. Repeat entry with correct search target.
Program
Clear alarm with the Delete key or NC START.
Continuation:
15380
[Channel %1: ] Block %2 illegal incremental programming in axis %3
Parameters:
%1 = Channel number
%2 = Block number, label
%3 = Axis
Definitions:
The first axis programming after "search to block end point" is performed incrementally. This is not allowed in the fol-
lowing situations:
- After searching the target a transformation change has taken place.
- A frame with rotation component is active. The programmed axis is involved in the rotation.
Reaction:
Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Alarms
Diagnostics Manual, 07/2010, 6FC5398-8BP40-0BA0
NCK alarms
213
Hide quick links:
Advertisement
Table of Contents
