Block %2: Cycle72 Cannot Be Simulated; Block %2: Infeed Width Is Not Programmed; Block %2: Technology Selection Parameter Incorrectly Defined - Siemens Sinamics S120 Diagnostic Manual

NCK alarms
Reaction: Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy: Define the safety clearance.
Program Clear alarm with the RESET key. Restart part program
Continuation:
61123 [Channel %1: ] Block %2: CYCLE72 cannot be simulated
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: Alarm triggered by following cycle: CYCLE72.
Reaction: Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy:
Program Clear alarm with the RESET key. Restart part program
Continuation:
61124 [Channel %1: ] Block %2: Infeed width is not programmed
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: Alarm triggered by following cycle: CYCLE71.
Reaction: Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy: With active simulation without tool, a value for the infeed width _MIDA must always be programmed.
Program Clear alarm with the RESET key. Restart part program
Continuation:
61125 [Channel %1: ] Block %2: Technology selection parameter incorrectly defined
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: Alarm triggered by following cycles: CYCLE84, CYCLE840.
Reaction: Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy: Check technology selection parameter (_TECHNO).
Program Clear alarm with the RESET key. Restart part program
Continuation:
390
Diagnostics Manual, 07/2010, 6FC5398-8BP40-0BA0
Alarms