Block %2 Coordinate %3 Programmed Repeatedly In The Block; Block %2 Geometry Axis %3 Cannot Traverse; Block %2 Rotation Programmed For Non-Existent Geometry Axis; Block %2 Chamfer Or Rounding Negative - Siemens Sinamics S120 Diagnostic Manual

NCK alarms
16424 [Channel %1: ] Block %2 coordinate %3 programmed repeatedly in the block
Parameters: %1 = Channel number
%2 = Block number, label
%3 = Coordinate
Definitions: It is not allowed to program a coordinate of the 2nd contact point of the tool for description of the tool orientation several
times in one block.
Reaction: Correction block is reorganized.
Interface signals are set.
Alarm display.
Remedy: Modify part program.
Program Clear alarm with NC START or RESET key and continue the program.
Continuation:
16430 [Channel %1: ] Block %2 geometry axis %3 cannot traverse as positioning axis in
rotated coordinate system
Parameters: %1 = Channel number
%2 = Block number, label
%3 = Axis name, spindle number
Definitions: In the rotated coordinate system, traversing of a geometry axis as positioning axis (i.e. along its axis vector in the
rotated coordinate system) would mean traversing of several machine axes. This is in conflict with the positioning axis
concept, however, in which one axis interpolator runs in addition to the path interpolator!
Reaction: Correction block is reorganized.
Interface signals are set.
Alarm display.
Remedy: Traverse geometry axes as positioning axes only with rotation deactivated.
Deactivate rotation:
Keyword ROT without further specification of axis and angle.
Example: N100 ROT
Program Clear alarm with NC START or RESET key and continue the program.
Continuation:
16440 [Channel %1: ] Block %2 rotation programmed for non-existent geometry axis
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: A rotation of a geometry axis which does not exist was programmed.
Reaction: Correction block is reorganized.
Interface signals are set.
Alarm display.
Remedy: Modify part program.
Program Clear alarm with NC START or RESET key and continue the program.
Continuation:
16500 [Channel %1: ] Block %2 chamfer or rounding negative
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: A negative chamfer or rounding has been programmed under the keywords CHF= ..., RND=... or RNDM=...
226
Diagnostics Manual, 07/2010, 6FC5398-8BP40-0BA0
Alarms