Axis Range Limits Are Equal; Name Of Program To Be Generated Is Missing; Contour %4 Does Not Exist; Label %4 Not Existing In The Pocket Contour - Siemens Sinamics S120 Diagnostic Manual

61818 [Channel %1: ] Block %2: Axis range limits are equal
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: --
Reaction: Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy: --
Program Clear alarm with the RESET key. Restart part program
Continuation:
61900 %[[Channel %1: ] Block %2: %]Name of program to be generated is missing
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: Alarm triggered by following cycles: CYCLE63, CYCLE64
Reaction: Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy: - Check parameter PRG
Program Clear alarm with the RESET key. Restart part program
Continuation:
61901 %[[Channel %1: ] Block %2: %]Contour %4 does not exist
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: Alarm triggered by following cycles: CYCLE63, CYCLE64
Reaction: Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy: - Check contour call
- Check whether the contours exist in the program storage (workpieces, subroutines or part programs)
Program Clear alarm with the RESET key. Restart part program
Continuation:
61902 %[[Channel %1: ] Block %2: %]Label %4 not existing in the pocket contour
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: Alarm triggered by following cycles: CYCLE63
Reaction: Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy: - Check whether the labels exist in the pocket contour
Program Clear alarm with the RESET key. Restart part program
Continuation:
Alarms
Diagnostics Manual, 07/2010, 6FC5398-8BP40-0BA0
NCK alarms
479