Block %2: Number Of Holes Is Zero; Block %2: Contour Violation Of Slots; Block %2: Milling Cutter Radius Too Large; Block %2: Number Of Or Distance Between Circular Elements - Siemens Sinamics S120 Diagnostic Manual

61103 [Channel %1: ] Block %2: Number of holes is zero
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: No value for the number of holes has been programmed. Alarm triggered by following cycles: HOLES1, HOLES2.
Remedy: Check parameter NUM.
Program Clear alarm with the RESET key. Restart part program
Continuation:
61104 [Channel %1: ] Block %2: Contour violation of slots
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: Incorrect parameterization of the milling pattern in the parameters which define the position of the slots/elongated
holes on the circle and their form. Alarm triggered by following cycles: SLOT1, SLOT2, LONGHOLE.
Reaction: Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy: --
Program Clear alarm with the RESET key. Restart part program
Continuation:
61105 [Channel %1: ] Block %2: Milling cutter radius too large
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: The diameter of the cutter used is too large for the form to be machined. Alarm triggered by following cycles: SLOT1,
SLOT2, POCKET1 to POCKET4, LONGHOLE, CYCLE90.
Reaction: Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy: Either a tool with a smaller radius has to be used or the contour must be modified.
Program Clear alarm with the RESET key. Restart part program
Continuation:
61106 [Channel %1: ] Block %2: Number of or distance between circular elements
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: Incorrect parameterization of NUM or INDA. The layout of the circle elements within a full circle is not possible. Alarm
triggered by following cycles: HOLES2, LONGHOLE, SLOT1, SLOT2.
Reaction: Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy: Correct parameterization.
Program Clear alarm with the RESET key. Restart part program
Continuation:
Alarms
Diagnostics Manual, 07/2010, 6FC5398-8BP40-0BA0
NCK alarms
385