Block %2: %]Machining Plane Wrongly Programmed; Machining Plane On Cycle Call Differs From The One In Position Pattern; Block %2: Residual Material Remains Stationary, Reduce Plane Infeed; Block %2: Centering Diameter Or Tool Parameter Are Incorrect - Siemens Sinamics S120 Diagnostic Manual

NCK alarms
61157 %[[Channel %1: ] Block %2: %]Reference point wrongly programmed
Parameters: %1 = Channel number
%2 = Block number, label channel number
Definitions: The alarm is triggered by the following cycle: CYCLE63, CYCLE64, CYCLE899
Remedy: Check reference point in screen form, input only -X, centred or +X
61158 %[[Channel %1: ] Block %2: %]Machining plane wrongly programmed
Parameters: %1 = Channel number
%2 = Block number, label channel number
Definitions: The alarm is triggered by the following cycle: CYCLE63, CYCLE64, CYCLE899, CYCLE952
Remedy: Check machining plane (G17, G18 or G19)
61159 [Channel %1: ] Block %2: Machining plane on cycle call differs from the one in the
position pattern
Parameters: %1 = Channel number
%2 = Block number, label channel number
Definitions: The alarm is triggered by the following cycle: CYCLE899
Remedy: Adjust the machining plane on cycle call to the machining plane in the position pattern.
61160 [Channel %1: ] Block %2: Residual material remains stationary, reduce plane infeed
Parameters: %1 = Channel number
%2 = Block number, label channel number
Definitions: The alarm is triggered by the following cycle: CYCLE899
Remedy: Reduce plane infeed or slot width, or use milling cutter with larger diameter
61161 [Channel %1: ] Block %2: Centering diameter or tool parameter (diameter, tip angle) are
incorrect
Parameters: %1 = Channel number
%2 = Block number, label channel number
Definitions: The alarm is triggered by the following cycle: CYCLE81
Remedy: - Diameter of centering with tip angle of active tool not possible
- Entered workpiece diameter, tool diameter or tip angle of tool incorrect
- Diameter of tool only has to be entered if centering is to be on workpiece diameter.
Program Clear alarm with the RESET key. Restart part program
Continuation:
61162 [Channel %1: ] Block %2: Tool parameter diameter or tip angle incorrect
Parameters: %1 = Channel number
%2 = Block number, label channel number
Definitions: The alarm is triggered by the following cycle: CYCLE81
Remedy: - The tool parameter diameter or tip angle must be greater than zero
- Tip angle must be less than 180°
396
Diagnostics Manual, 07/2010, 6FC5398-8BP40-0BA0
Alarms