Siemens Sinamics S120 Diagnostic Manual page 923

Locking save data /SAVEDATA/ No. 92
Definitions: Interlock for data recovery
Is not permitted if:
The NCK channel status is not Stopped
Machine data execution (external) /INITIALINIEXTSTART/ No. 36
Definitions: Start machine data processing (PI command)
(INI file is located externally (e.g.) on MMC)
Should not occur in any alarm
Machine data processing /INITIALINISTART/ No. 35
Definitions: Start machine data processing (PI command)
(INI file is already in the NCK)
Should not occur in any alarm
Move tool /TM_MOVETOOL/ No. 14
Definitions: Move tool (only with tool management) (PI command)
Should not occur in any alarm
Preprocess stop /INTERPRETERSTOP_ALARM/ No. 75
Definitions: Stop the preprocessing (alarm)
Should not occur in any alarm
Processing stop /STOPBAG/ No. 88
Definitions: Stop processing
(VDI signal, mode group stop)
Should not occur in any alarm
Program selection from other channel /CHANNEL_PROGSELECT/ No. 46
Definitions: Program selection from another channel (channel communication, NC block INIT)
Should not occur in any alarm
Program selection from other channel /INIT_SYNC/ No. 59
Definitions: Program selection from the other channel with synchronization
(Channel communication, NC block INIT + SYNC)
Should not occur in any alarm
Alarms
Diagnostics Manual, 07/2010, 6FC5398-8BP40-0BA0
List of actions
923