Block %2: Overwrite Traoridata, Yes -> Nc Start, No -> Reset; Tolerance Of The Linear Vector %4 Exceeded; Tolerance Of The Rotary Axis Vector %4 Exceeded; No Internal Correction Of The Calibration Data - Siemens Sinamics S120 Diagnostic Manual

NCK alarms
62315 [Channel %1: ] Block %2: Overwrite swivel data record TCARR = %4, yes -> NC start,
no -> reset
Parameters: %1 = Channel number
%2 = Block number, label channel number
Definitions: The alarm is triggered by the following cycle: CYCLE996
Remedy:
62316 [Channel %1: ] Block %2: Overwrite TRAORIdata, yes -> NC start, no -> reset
Parameters: %1 = Channel number
%2 = Block number, label channel number
Definitions: The alarm is triggered by the following cycle: CYCLE996
Remedy:
62317 [Channel %1: ] Block %2: Tolerance of the linear vector %4 exceeded
Parameters: %1 = Channel number
%2 = Block number, label channel number
Definitions: The alarm is triggered by the following cycle: CYCLE996
Remedy:
62318 [Channel %1: ] Block %2: Tolerance of the rotary axis vector %4 exceeded
Parameters: %1 = Channel number
%2 = Block number, label channel number
Definitions: The alarm is triggered by the following cycle: CYCLE996
Remedy:
62335 [Channel %1: ] Block %2: No internal correction of the calibration data
Parameters: %1 = Channel number
%2 = Block number, label channel number
Definitions: Alarm triggered by the following cycles: CYCLE961, CYCLE977, CYCLE978, CYCLE979, CYCLE996, CYCLE997,
CYCLE998
Remedy: Check probe alignment/spindle position!
The alignment (programmed position) of the tool probe in the workspindle must be identical during calibration
and measuring!
If these positions vary, the calibration data cannot be corrected cycle-internally with regards to a coordinate
rotation of the workplane around the infeed axis!
498
Diagnostics Manual, 07/2010, 6FC5398-8BP40-0BA0
Alarms